ET107 Weather Station
30
The ET107 comes with a default program (see Appendix
(p. E-1)
Use standard time in the station if calculating. Do not use daylight
savings time.
5.6 Communication Peripherals
Communication kits ordered with the enclosure are pre-mounted and
pre-wired; no further connections inside the enclosure are necessary. Follow
the external installation procedures in later sections to make the external
connections.
If you received a telecommunication kit separate from the enclosure, follow the
“Internal Installation” procedures outlined in later sections. Schematics for the
phone and short haul modems are in Section
(p. 70)
.
Default settings for the CR1000 in the ET107 station:
•
PakBus address 1
•
RS-232 Port: Autobaud (300 to 115,200 bps)
•
ME: Autobaud
•
SDC7 or SDC8: 115,200 bps
5.6.1 Direct Connect to ET107 Station
The ET107 station does not require an interface device for direct RS-232
communication. The inside of the enclosure has a RS-232 and CS I/O port
available for communication (see FIGURE
). Most standard
communication options use the CS I/O port leaving the RS-232 port free for
direct communication with a laptop or desktop computer using a standard RS-
232 serial cable. The CR1000 datalogger used in the ET107 station can
communicate with more than one device at a time allowing troubleshooting to
be done in the field with a laptop while remote communication devices are
accessing the station.
Use
Device Configuration Utility
(
DevConfig
) and connect
directly to the station to change the CR1000 configuration.
DevConfig
is included with
LoggerNet
and can be obtained, at no
NOTE
NOTE
NOTE