FIGURE 7-1. EE181 sensor placement in a RAD10E multi-plate shield
Tools required:
l
1/2 inch open-end wrench
l
small screwdriver provided with data logger
l
UV-resistant cable ties
l
small pair of diagonal-cutting pliers
l
Adjustable wrench with a minimum 1-7/8 inch jaw size
Attach the probe to the cable by aligning the keyed connectors, pushing the connectors
together, and finger tightening the knurled ring.
CAUTION:
Only finger tighten the knurled ring. Using a wrench may damage the connector.
7.3.1 Shield installation
Campbell Scientific recommends the EE181 with the MetSpec RAD10E multi-plate radiation shield
due to shield performance in bright sunlight and low wind speeds as well as over snow or
reflective surfaces. The EE181 will work with the RM Young 10-plate shield but requires an adapter
to accommodate sensor girth.
EE181 Temperature and Relative Humidity Probe
10
