Campbell CSAT3B, Инструкция по эксплуатации, Страница: 36 / 88

CSAT3B Three-Dimensional Sonic Anemometer
FIGURE 7-3. CM210 mounting kit with CM20X crossarm
2. Point the horizontal arm into the direction of the prevailing wind and
tighten the nuts and bolts of the mounting hardware.
3. Attach the CM250 leveling mount (pn 26559; included with the
CSAT3B) to the crossarm by tightening the set screws on the boom
adapter with a 3/16-in hex socket head wrench. Refer to FIGURE
7-4.
4. Attach the CSAT3B to the leveling mount by inserting the bolt on the
mount into the threaded hole on the bottom of the CSAT3B block as
shown in FIGURE 7-4.
5. Lightly tighten the bolt and then proceed to the leveling steps.
Do not carry the CSAT3B by the arms or the strut between
the arms. Always hold the CSAT3B by the block, where the
upper and lower arms connect.
Over-tightening bolts will damage the screw threads in the
CSAT3B block.
CAUTION
CAUTION
26