Campbell CR1000X, Руководство по эксплуатации продукта

Страница: 134 / 238

9.4.1 Program does not compile
When a program is compiled, the CRBasic Editor checks the program for syntax errors and other
inconsistencies. The results of the check are displayed in a message window at the bottom of the
main window. If an error can be traced to a specific line in the program, the line number will be
listed before the error. Double-click an error preceded by a line number and that line will be
highlighted in the program editing window. Correct programming errors and recompile the
program.
Occasionally, the CRBasic Editor compiler states that a program compiles OK; however, the
program may not compile in the datalogger itself. This is rare, but reasons may include:
l
The datalogger has a different operating system than the computer compiler. Check the
two versions if in doubt. The computer compiler version is shown on the first line of the
compile results. Update the computer compiler by first downloading the executable OS file
from www.campbellsci.
eu
. When run, the executable file updates the computer compiler.
To update the datalogger operating system, see Updating the operating system (p. 109).
l
The program has large memory requirements for data tables or variables and the
datalogger does not have adequate memory. This normally is flagged at compile time in
the compile results. If this type of error occurs:
o
Check the CPU drive for copies of old programs. The datalogger keeps copies of all
program files unless they are deleted, the drive is formatted, or a new operating
system is loaded with Device Configuration Utility.
o
Check the USR drive size. If it is too large it may be using memory needed for the
program.
o
Ensure a memory card is available when a program is attempting to access the CRD
drive.
9.4.2 Program compiles but does not run correctly
If the program compiles but does not run correctly, timing discrepancies may be the cause. If a
program is tight on time, look further at the execution times. Check the measurement and
processing times in the Status table (MeasureTime, ProcessTime, MaxProcTime) for all scans, then
try experimenting with the
InstructionTimes()
instruction in the program. Analyzing
InstructionTimes()
results can be difficult due to the multitasking nature of the
datalogger, but it can be a useful tool for fine-tuning a program.
9.5 Resetting the datalogger
A datalogger reset is sometimes referred to as a "memory reset." Backing up the current
datalogger configuration before a reset makes it easy to revert to the old settings. To back up the
9. Tips and troubleshooting 118