Campbell CCFC, Руководство по эксплуатации продукта

Страница: 121 / 144

17.3.4 Example data logger program – adding GPS
coordinates to the photo banner
A downloadable example program using
CCFCGPSLatitude
and
CCFCGPSLongitude
instructions to add GPS coordinates to the photo banner is available at
www.campbellsci.com/downloads/ccfc-program-examples .
17.4 PakBus® neighboring address
The PakBus® protocol allows devices to relay data in a network. The CCFC can communicate
with devices that are several hops away on the PakBus® network. A setting on the web page
PakBus® configuration screen configures this feature.
Type the address of the PakBus® device connected to the CCFC PakBus® communication lines
and the neighbor device will relay communications between the CCFC and the final destination
for data. Set the PakBus® address to zero (0) if the CCFC is directly connected to the final
destination.
18. Power calculations and
timings
The CCFC was specifically designed for operation in power-constrained systems such as solar
powered sites. It is critical in such systems that the camera be properly configured to meet the
constraints of the intended application. This section outlines the power consumption of the
camera for purposes of power supply design for a system.
l
An active session to the camera with a web browser prevents the camera from entering a
low powered state.
l
Avoid removing power from the camera when it is in an active state. If the camera is in an
active state (Status LED is flashing), properly shutdown the camera to avoid any memory
corruption before removing power. The camera can be shut down by holding the Setup
Button continuously for more than 10 seconds or by using the Power Icon on the web
interface.
CCFC Field Camera 115