CAMPAGNOLA T-REX, Руководство по эксплуатации и обслуживанию

Страница: 39 / 368

Use and maintenance manual – Translation of
original Instruction.: 01, Date 04/11/2021
Page 39
If the chain (1) is new, it requires a break-in period during which its tension must be checked more often.
6.1.2 Replacing the chain or the cutting bar
Perform the following operations in sequence:
• Switch off the tool by means of the ON / OFF button (10) and remove the battery (16) by pressing on the releasing
plates (17).
• Completely unscrew the nuts (3) anti-clockwise to remove the front guard (5).
• To loosen the chain (1), turn the adjustment screw (4) anti-clockwise until it stops.
• Remove the bar (2) and the chain (1) to be replaced.
• Insert the tabs of the chain transmission teeth into the groove of the bar. The arrows on the connecting links, in the
upper part of the bar, must be directed towards the bar tip.
• Position the bar (2) and chain (1) on the tool, making sure that:
- the chain drive links are inserted on the pinion teeth
- the slot in the bar is inserted in the drive on the tool body (23).
- the pin of the chain tensioner (24) is inserted in the hole (25) of the bar.
• Reassemble the guard (5) and screw the nuts (3) without tightening them.
• Tension the chain by turning the adjusting screw (4) clockwise, so that it is well tensioned and can be easily moved
manually.
• When the correct tension is reached, lock the nuts (3).
The bar (2) can be mounted in any position, even if the Campagnola logo is upside down.
Make the chain (1) run at low speed for a few minutes before starting to cut, in order to allow the oil to reach all
parts of the chain (1) and bar (2). Make chain (1), bar (2) and pinion warm up completely.
Make sure that the first cuts are light and take care that there is always a large quantity of oil. Avoid any too
strong pressure.