CAMPAGNOLA T-REX, Руководство по эксплуатации и обслуживанию

Страница: 37 / 368

Use and maintenance manual – Translation of
original Instruction.: 01, Date 04/11/2021
Page 37
5.2 Not allowed uses
• Do not use the tool when being in unstable balance.
• Do not cut materials which are different from wood.
• Do not use the tool as a lever or to lift, move or break any object.
• Do not use the tool if the atmosphere is explosive or inflammable.
5.3 Tool transport
When carrying the tool, keep its bar (2) facing backwards and inside its guard (15).
For long transports taking more than 15 minutes, keep the tool in its packaging. This prevents accidental damages to
things and/or injuries to people and/or damages to the tool during transport
5.4 Storing the tool
In case of long periods of tool inactivity:
• Follow all the maintenance indications in the manual.
• Empty the oil reservoir (14) and close its plug (12).
• Remove the cutting residues (sawdust) from the front cover (5).
• Perfectly clean and re-assemble the tool.
• Put the bar into its guard (15).
• Recharge the batteries before putting them into the carrying case.
• Clean the tool and put it with its components into its case.
• Store the tool in a dry place.
• During long periods of inactivity recharge the batteries not later than every 3 months.
5.5 Troubleshooting
All the following maintenance operations shall be carried out by a maintenance technician.
FAULT POSSIBLE CAUSE REMEDY
The tool does not
work.
Flat battery Recharge the battery (16)
Disconnected battery
Check the proper connection of the battery (16)
with the tool
Possible electronic or mechanic problem Take the tool to an Authorized Service Point.
The tool cutting
strength decreases
The battery is flat
Recharge the battery (16)
The chain is not sharp Sharpen or replace the chain (1)
The chain is too tensioned Regulate the chain (1) tension
Scarce lubrication Add oil into its reservoir (14)
The chain stops.
The chain is not tensioned enough Regulate the chain (1) tension
Scarce lubrication Add oil into its reservoir (14)
The chain skips
while cutting.
Worn chain
Sharpen the chain (1)
Damaged chain Replace the chain (1)
The lubrication is
not enough.
Low oil level in the reservoir (14) Add oil into its reservoir (14) using the plug (12)
The battery does
not get completely
recharged.
Damaged battery.
Replace the battery (16)
Faulty battery charger. Replace the battery charger (18)
Unsuitable battery charger.
Check that the battery charger (18) is the one
supplied with the tool.