Use and maintenance manual – Instructions
Original instructions Rev.: 00, Date 11/04/2022
Page 31
1 INTRODUCTION
1.1 Functions and use of the Use and Maintenance Manual
Before working on the machine, carefully read and understand this Use & Maintenance Manual in order to safeguard the
operator and to avoid damaging the machine. These instructions describe how to operate the product safely, economically
and in compliance with the current safety regulations. Following these instructions helps avoid dangerous situations, reduces
repair costs and down-time of the product and extends the life-span of the product itself. This manual must be intact and
legible in its entirety. Every operator involved in using the product or in charge of maintenance must know the location and
be able to read it whenever needed.
1.2 Symbols and qualification of operators
All human-machine operations herein described must be performed by personnel defined in compliance with the manufacturer’s
manual. Each procedure is accompanied by a pictogram which indicates the operator considered most suitable for the tasks to
be performed. The indication to identify the personnel qualifications are given below.
Operator
Personnel who can install, operate, adjust, clean, transport the machine and carry out its routine maintenance.
Mechanical maintenance technician
Mechanical personnel with specific skills, able to perform installation, extraordinary maintenance and/or repairs indi-
cated in this manual.
Electrical / electronic maintenance technician
Personnel with specific electric/electronic skills capable of performing installation, extraordinary maintenance and/or
repairs and of operating the product even when the safety and protective systems are partially or fully disabled. This
person is not qualified to perform mechanical interventions.
The workshop authorised to carry out repairs on the Manufacturer’s machines.
CAUTION!
Precautions to be taken in order to safeguard the operators and bystanders in the work area.
IMPORTANT!
Note to be taken in order to avoid problems with the product or to operate in compliance with the current safety
regulations.
1.3 Declaration of conformity
Every machine destined to countries included in the European Union (EU) is supplied with adequate characteristics to
the requirements of the Machinery Directive 2006/42/EC. The relevant manufacturer’s Declaration of conformity is at-
tached to the Use and Maintenance Manual.
1.4 Receiving the product
When receiving the product, make sure that:
•
it has not been damaged during transportation;
•
the supply matches the order and includes all the supplied parts (see par. 3.2 and 3.3).
If problems arise, please contact the manufacturer’s Service Department quoting all details indicated on the rating plate
(refer to par.3.1).
1.5 Warranty
For the general warranty conditions check the Campagnola website
, or send a written request
to the fax number 051752551, or send an e-mail to:
CAUTION!
For warranty claims, according to the above-mentioned points, the product to be repaired must always be accompa-
nied by the properly filled-in warranty card and the corresponding proof of purchase with date of purchase (invoice or
any other document with legal value).
AUTHORISED WORKSHOP