CAMPAGNOLA Stark Series, Руководство по эксплуатации и обслуживанию

Страница: 28 / 272

Pag. 28
Use and maintenance manual – Translation of
original Instruction.: 03, Date 11/03/2021
DANGER
The optional metal wire anti-cut function is NOT a safety function aimed at protecting the person, but it is
aimed solely and exclusively, where possible, to limit any damage to the wire or wires supporting the vege-
tation and / or shoots, etc.
Activation / deactivation of the function:
To activate this optional metal wire anti-cut function carry out the following operations:
• The shear must be turned off.
• Press and hold down the power button for at least 10 sec. until you hear the third “beep” (acoustic signal).
The optional function is now active and functioning.
To deactivate the optional function carry out the following operations:
a) Switch off the shear.
b) Press and hold down the power button for at least 10 sec. until you hear the third “beep” (acoustic signal).
c) Turn off the shear again and put it back into its carrying case.
The optional function is now disabled and cannot work.
!
WARNING
The optional metal wire anti-cut function must always be deactivated before storing the tool, or in all cases
where it is not used.
5.2.2 Function description:
Once the optional function has been activated, in order to make it operate, the operator must hold the support wire of
the vegetation and / or branches with his free hand at a MINIMUM distance 15 cm from the cutting point on the
branch, i.e. from the shear blades.
DANGER
It is mandatory to always keep at least a distance of 15 cm between the hand holding the metal wire and the
branch or shoot to be cut, in order to avoid a risk of injury to the operator’s limbs.
The contact between the free hand and the metal wire must be preferably through the use of conductive metal gloves.
In these conditions, if the blade accidentally touches the metal wire, the cut is interrupted and the blade returns to the
open position, thus avoiding accidental damage to the wire and consequent restoration costs.
Any other use of this optional function other than the above mentioned is not permitted by the Manufacturer and is
prohibited. Moreover, it constitutes an improper use of the tool.
The Manufacturer disclaims any liability due to damage to property or people caused by an improper, unauthorized
use of the tool and / or not in accordance with the instructions supplied with the tool.
DANGER
Depending on the operations to be carried out, an improper use of the tool entails considerable risks and are
prohibited.
DANGER
The tool supplied must be used exclusively by qualified and trained operators who have read and understood
this manual and only and exclusively in compliance with the recommendations contained therein.
5.2.3 Blade opening mode
Switch the scissors on and press the trigger twice: the blade is 100% open.
With the scissor on, keep the trigger pressed until a beep is heard: the blade is 70% open.
In 70% blade opening mode, quickly press the trigger twice: the blade will open to 100% for a single cut, and then re-
turn to the previously chosen opening.
Return to 100% blade opening by keeping the trigger pressed until the beep is heard again, then switch the scissors
off and on again
Storing the shear
• Keep the trigger pressed for few seconds until you hear 3 long beeps. The blades close and remain closed. Release
the trigger.
• Switch the shear off and remove the battery.
• Recharge the battery before putting it into its box.
• Clean the shear and put it back with its components into its box.
• Store the shear in a dry place.
• For long periods of inactivity recharge the batteries not later than every 3 months.