Use and maintenance manual – Translation of
original Instruction Rev.: 01, Date 01/02/2022
Pag. 19
3.7 Safety devices
•
Built-in safety device –
Automatic switch-OFF
: if not used for over 20 minutes and with the charge level over 20%,
the power supply is switched off.
•
With the charge level of the battery below 20%, the automatic switch-off occurs in 5 minutes.
•
Use the
ON/OFF
button (4) to restart the battery.
•
Built-in protection device: Protects the battery set avoiding that the voltage increases or decreases too much, consid-
ering the indicated thresholds.
4.1 Starting
•
Remove the components from the packaging.
•
Recharge the batteries (2) (see par. 5.3).
•
Fit the battery set (2) onto the backpack (3) by following the instructions in par. 4.2.
•
Plug the cable (1) taking care of the male/female connections.
4.2 Fitting the battery set onto the backpack
•
Remove the backpack (3) and the battery (2) from the packaging.
•
Insert the fixing supports (10) into the lower pocket of the backpack.
•
Insert the fixing belts of the backpack into the corresponding fixing slots on the top of the battery (9)
•
Fasten the fixing belts inside the backpack (3).
5.1 Starting the unit
•
Wear the backpack (3) and adjust the belt length by means of the buckle.
•
Adjust the braces buckle so that they cannot slip from the shoulders.
•
Turn the button
ON
(4).
•
Use the unit only for the purposes described in par. "Description of the Product". Any other use may cause
injuries.
•
The backpack (3) shall be positioned in such a way that the 90% of its weight is supported by the operator’s
waist instead of by his back.
•
The braces shall be used to improve the weight balancing (10%).
5.2 Display
After quickly pressing the ON/OFF button (11) on the display (9), the charge level will be visible for about 5 seconds with
the following modes:
• 4 led bars – 80/100% charge level
• 3 led bars – 60/80% charge level
• 2 led bars – 40/60% charge level
• 1 led bar – 20/40% charge level
• 1 flashing led light – charge level is lower than 20%
• All flashing LED lights with repetition each second = Error status.
If any undervoltage is detected, it persists even if the battery is switched off and then on again, until it reaches at least the
20% of its status of charge (SoC).
If the problem cannot be solved, take the battery to an Authorized Service Point.
5.2.1 ON/OFF battery led light
When the button is pressed while switching off the battery, the timed lit-up led bars quantity will decrease up to zero.
When the last LED bar is off, the battery switches off by releasing the button.
Содержание Li-Ion 700
Страница 3: ...Manuale Uso e Manutenzione Istruzioni Originali Rev 01 Data 01 02 2022 Pag 3 ...
Страница 50: ......
Страница 51: ......