background image

is only permissible if the cylinder is 
disconnected and removed from the 
fire pit.

OPERATING INSTRUCTIONS

Lighting Procedures
1. Check all connections for leaks 
using the “soapy water” test.
2. Check for any blockage to the
venturi tube or burner. Remove any 
foreign objects or matter.
3. Be sure the burner control knob is 
“OFF”.
4. Open the LP cylinder valve ONLY
1-1/2 turns by turning 
counterclockwise.
5. Insert a 
long-nose gas 
lighter next 
to the burner, 
making sure 
it sits over the 
burner. Open 
the valve next 
to the burner 
by turning the lever to the ON 
position. If the burner does
not light within 4 or 5 seconds, turn 
the control knob off, wait 5 minutes, 
and repeat the process.

ShUTTING ThE FIRE PIT OFF

Turn the control knob at the 
regulator off by turning clockwise 
The burner flame should then go 
out. Turn off the LP cylinder valve 
by turning the knob clockwise 

CAUTION

The fire pit can become very 
hot while in use. Do not 
touch any portion of the fire 
pit except for the control 
knob next to the regulator. 
It may be necessary to use 
protective gloves.

until it stops. Follow instructions 
in this manual for proper storage 
procedures and the important 
warnings and safe guards on pages.
When an LP tank is not connected, 
and to help prevent dirt or other 
foreign particles from clogging the 
HVR, hang the end of the HVR hose 
from the outer ring.

Inspect the flame at the burner to 
ensure a proper flame.

To protect your fire pit from 
weather, always keep your fire pit 
covered while not in use. The cover 
must be removed and stored safely 
away from the fire pit when the fire 
pit is in use.

ClEANING

Clean the stand of the fire pit using 
hot soapy water. High temperature 
spray paint can be used to touch 
up any scratches in the paint. Use 
a wire brush to remove any loose 
paint before touching up. Make sure 
to dry thoroughly before use. The 
rocks can be removed from the fire 
pit and cleaned using soapy water or 
sprayed off using a hose sprayer. The 
outside of the burner may be wiped 
clean using soapy water. A pipe 
cleaner can be used to remove any 
spider webs from the venturi tube.

OFF

ON

Control Valve

0809-GCLOG-Instructions

MOdEl #: GC-lOG-2
PROPANE FIRE RING

Warning & Instruction Booklet

FOR OUTDOOR Use ONLY

Read this manual before each use. Failure to follow these instructions

could result in fire or explosion, which could cause serious personal

injury and/or property damage.

Po Box 4057 • Logan, UT 84323 • 1.800.650.2433 • www.campchef.com

0809-GCLOG-Instructions.indd   1-2

8/19/09   10:11:12 AM

Отзывы: