6
INSTALLATION, REMOVAL AND RE-INSTALLATION
INSTALLATION, REMOVAL
AND RE-INSTALLATION
Always follow good shop practices. The place where you will be
working must be clean, bright and well ventilated. If you are to
use a floor jack, never use it as a stand. Always use appropri-
ate stands. To avoid vehicle movement during operations,
place blocks behind wheels that remain in contact with the
ground. These recommendations also apply when removing
parts.
Read this manual before proceeding with the installation
work. Read Installation Guidelines included with the Sys-
tem for installation instructions dedicated to your UTV
model.
Installation
Execute all tasks described in Installation Guidelines of the
vehicle model. Then, proceed to adjust the angle of attack,
alignment and track tension as described in this manual. Test
drive and re-adjust as required.
Removal
CAUTION: Leaving anchor brackets attached to suspension
arms or anti-rotation bars attached to the skid plate when the
UTV rides on wheels will damage the vehicle. Never leave
components other than the skid plate and foot rest
reinforcement parts.
Using a lifting device, raise the UTV and install appropriate
stands. Ensure that the vehicle is immobilized and safe to work
on.
At the front:
• Remove the anti-rotation bracket cover but keep the
anchor bracket attached to the anti-rotation device on
the track system.
WARNING
Never place body parts under the vehicle unless it is
securely placed on appropriate stands. Severe injuries
could occur if the vehicle collapses or moves. Do not use a
lifting device as a secure stand.
Содержание Tatou
Страница 1: ...User Manual TATOU UTV Track System ...
