PM 1001484 000 08
Device handbook SINEAX DM5000
42/96
6.7 Simulation of analog / digital outputs
To check if subsequent circuits will work properly with output values provided by the device, using the
service menu
Simulation
all analog or digital / relay outputs may be simulated. This is done by either
entering analog output values or selecting discrete states for the digital outputs / relays.
When output simulation is turned on, the device configuration will be changed. This may take a few
seconds. Once the simulation is turned off, the device is switched off or the menu selection is changed,
the device goes back to its initial configuration.
Simulation is possible via webpage and as well via the local display.
Simulation of digital outputs via device webpage
6.8 Security system
6.8.1 Protection against device data changing
Configuration or measurement data stored in the device may be modified via either service or settings
menu. To protect these data a security system may be activated (default: not activated). If the security
system is active the user has to enter a password before executing protected functions. Subsequent to a
successful password input the access remains open until the user leaves the settings / service menu or
an input timeout occurs.
The password can be modified by the user. Permitted characters are ‘a‘…‘z‘,
‘A‘…‘Z‘ and ‘0‘…‘9‘, length 4…12 characters.
ATTENTION
: A reset to factory default will reset also the password (factory setting:
„1234“). But for a factory reset the present password needs to be entered. If this
password is no longer known the device must be sent back to the factory!
Display
Webpage
Password input
Release
•
Click on the symbol
•
Enter password
•
Select Login
Protected functions can be used