Cameron NUFLO MC-III EXP, Руководство пользователя

Страница: 112 / 143

A-7
MC-III™ EXP Flow Analyzer Appendix A
User-Supplied Hardware
To connect the USB adapter to an MC-III using MC-III software, a user-supplied universal serial bus USB
A/B cable is required (Figure A.9).
Figure A.9—User-supplied USB A/B cable
Using the Adapter
The MC-III software CD supplied with the NuFlo USB Adapter contains the drivers required to enable USB
communications for an MC-III when the NuFlo USB Adapter is installed.
For step-by-step installation instructions, insert the CD in your computer and click the “Install USB Driver”
link on the Welcome screen. The software will install the appropriate driver that is compatible with your
computer’s operating system.
When the software is fully installed, the adapter can be connected to the computer and used to connect to the
MC-III via MC-III software (Tools/Select COM Port).
!
WARNING: When a hazardous area is present, ensure the union nut and blanking plug are
properly fitted in the conduit opening. The explosion-proof rating applies only when the union
nut and blanking plug are secured in place. When the union is broken, the device is no longer
explosion-proof.
!
WARNING: Before disassembling the union nut and blanking plug, make sure the area is non-
hazardous.
Covering the Adapter
When the USB port is not in use, nest the blanking plug inside the union nut and screw the union nut onto the
adapter to cover the USB socket. Hand-tighten to ensure a snug connection.
Adapter Kit Installation
If the NuFlo USB adapter is purchased as a kit, install it in the MC-III EXP according to the steps below.
The USB adapter is comprised of a USB adapter socket, a blanking plug, and a union nut (
Figure A.8, page A-6
).
The blanking plug and union nut are connected to the adapter only when the USB port is not in use.
1.
Remove the plug from a conduit opening in the MC-III EXP enclosure.
2. Thread the cable of the adapter through the conduit opening and screw the adapter into place.