CV-601 MProx
Installation Instructions
GENERAL DESCRIPTION
Camden CV-601 is an access control system for one
door.
The controller has an input for a proximity card reader
(included as part of the system), a 5 amp relay to
activate an electric lock and memory for up to 999
users.
The controller has 4 programming buttons and a 3-digit
display for:
1. Programming new cards/fobs into the memory
(individually or by batch enrolling).
2. Deleting cards/fobs from the memory (individually,
by sets, or all).
3. Selecting either Maintained (latching) or Timed
Operation mode, (and adjusting time delay).
4. Setting a User Password to protect programming
operations.
The controller is supplied in a plastic enclosure suitable
for indoor installation and for mounting on supplied
rails. The proximity card reader is door jamb width, and
is designed for indoor or outdoor applications.
FUNCTIONS
1. Programming new credentials (cards or fobs) into
the system
Cards or fobs are enrolled into individual memory slots,
numbered 1-999. In order to enroll a card/fob, the
memory slot must be “free” (non-assigned). When
programming the system, be sure to keep a record
(excel spreadsheet or paper record) of who has been
enrolled, and to which memory slot they were assigned.
Should that person lose their card/fob, or you wish to
cancel that person’s access privileges, it is essential that
you have a record of which memory slot they were
assigned.
1.1 Individual enrollment of cards or fobs
a) Press the RED and BLUE buttons simultaneously
b) Select a free (non-assigned) storage location. Hit the
red button to scroll up, or the blue button to scroll
down. Assigned locations will have decimals points
between the displayed numbers. Non-assigned
(free) locations are indicated by decimals points
being off.
c) Once you have found a free slot, present the badge
to be enrolled (card of fob) to the proximity reader
(decimal points will go on).
d) Confirm your selection by pressing the GREEN button
(decimal points will briefly flash).
e) Repeat steps b-d to enter other credentials or
simultaneously press RED and BLUE buttons to exit
from programming mode.
1.2 Batch loading of cards or fobs
Cards/fobs may be quickly enrolled in the system in
“batches”, rather than on a “one by one” basis.
The credentials to be enrolled must be sequentially
numbered in order to do so.
a) Press the RED and BLUE buttons simultaneously to
access the programming mode.
b) Press the YELLOW button to access the Function
selection menu.
c) Select Function F03 by pressing the red button twice.
d) Confirm this selection by pressing the GREEN button.
Package Contents
- (1) Programming Controller
- (1) Proximity Card Reader with plug-in
cable
- Hardware package with controller
mounting bracket and screws
- (2) 47V rated varistors (MOV)
