Electrified Locks, Relays and Timers
CX-PS150UL
POWER SUPPLY / CHARGER FOR ACCESS CONTROL
AND EGRESS DOORS
INSTALLATION INSTRUCTIONS
The CX-PS150UL is a power supply and charger that delivers a consistent
supply of 1.7 amps (1 amp for locking devices, 500mA for battery charging
and 200 mA for devices that need to stay powered regardless of the Fire
Alarm status) at a nominal voltage of either 12VDC or 24VDC. It features
two output terminals, one output is intended for maglock while the other is
intended for a strike, and is safeguarded against over current by a 2.5 amp
P.T.C. This power supply unit is designed to accommodate a 1 - 4Ah battery.
It is UL listed, adhering to the 7th Edition of UL294 standards, and also
meets the requirements of ULC-S533.
1. GENERAL DESCRIPTION
2. SPECIFICATIONS
Input
60Hz 1.8A max,120VAC for CX-PS150UL
Output
1 Amp continuous @ 12/24VDC
Auxiliary Output
200mA @ 12/24VDC
Dimensions
8-7/16”W x 9-5/16”H x 3-9/16”D
(214 mm x 236 mm x 91 mm)
UL294 PERFORMANCE LEVEL
4. BATTERY STAND-BY SPECIFICATION
NOTE:
This power supply should be installed in compliance with the National
Electric Code (NFPA 70) CSAC22.1, Canadian Electric Code, Part 1 and all
applicable Local Codes. Installation to be performed by qualified technical
personnel.
Destructive Attack
Level I
Line Security
Level I
Endurance Level
Level IV
Standby Power
Level IV
Page 1 of 4
3. KEY FEATURES
• Incorporates a built-in 500 mA battery charger for sealed lead acid or
gel cell batteries.
• Features battery reversal protection to safeguard against potential
damage.
• Designed for automatic switch over to stand-by battery in the event of
AC power failure.
• Equipped with LED indicators on the enclosure door for easy power
source monitoring: green LED for AC power, blue LED for DC power.
Output:
Stand-by 4 hr
Alarm 5 min
12VDC /4AHBattery
500mA
1A
24VDC /4AHBattery
500mA
1A
5. DIMENSIONS
8"
[203mm]
8 7/16"
[214mm]
9 5/16"
[236mm]
3 9/16"
[91mm]
3 3/8"
[85mm]
3 3/8"
[85mm]
3 13/16"
[97mm]
4"
[101mm]
3 1/4"
[83mm]
3 1/4"
[83mm]
CL
L
C
THIS PACKAGE INCLUDES
1 - Holding Screw
2 - 2K2 Resistors
1 - Instruction manual
1 - Strain Relief Connector
1 - Camden Programming Harness
