300, 400, 450, 500, 600 Wall and 600 Corner Wall Unit Assembly
Components
Ref. No.
Item
Quantity
Ref. No.
Item
Quantity
Ref. No.
Item
Quantity
Tools Required
1
2
Assembly Instructions
3
4
5
Important Information -
True Handleless Kitchens Installers
: See Note Above
TH
Modification required at this stage, see True
Handleless guide for further details.
TH
Modification required at this stage, see
True Handleless guide for further details.
TH
B
3
3
3
3
154085
8
8
154004
2
151999
5mm
Drill
Spirit Level
G-Clamp
(pair)
Medium Crosshead
Screwdriver
Hammer
Tape Measure
Bradawl
Large Flathead
Screwdriver
150101
4
3.5x12mm
154082
8
8
154027
152181
2
152162
2
150308
2
150309
2
152148
2
A
A
B
C
D
E
B
C
150126
4
4x30mm
152201
2
LH - 152246
RH - 152247
Pair
LH - 152248
RH - 152249
Pair
150199
6
4.5x45mm
152100
2
Note: The following are supplied in the
600 Corner Wall Unit conversion kit.
Note: E included in the 600
standard height and tall height
Corner Wall Unit conversion kit.
Standard Height Units
Tall Height Units
2
1
154082
8
2
8
154004
1
A
1 2
2 1
1 2
2 1
A
1
2
2
1
1
2
2
1
3
8
154083
3
B
B
3
3
3
3
4
5
D
4
4
4
4
4
4
4
4
Corner Wall Kit fitted to 600
Standard and Tall Height Units
152108
2
Caution: Some pieces of hardware could be hazardous to small children. Keep all these items out of reach and do not leave children unattended in the assembly area.
Please read these instructions carefully before proceeding. Refer to the Guide to Receiving and Installing your Kitchen booklet for further information.
Note:
Due to variation in wall conditions no screws are supplied for fixing the units to the wall. If in doubt consult an expert. Assemble the unit on a clean solid work surface.
In the interest of continuing improvements we reserve the right to amend or adjust the specifications without prior notice. Errors and omissions excepted.
Every effort has been made to ensure that this product leaves the factory in perfect condition. In the unlikely event that an item is damaged or incorrect, please contact the customer services department.
Note - Fitting Handles:
(1) Decide where you are going to position each handle to maintain symmetry around your kitchen. (2) Measure the handle centres and mark off each door/drawer position. (3) Drill through the door/drawer
using a fine drill (<2.5mm), then drill back from the rear face using a 4.5mm drill. (4) Attach with the fixings provided with your handle.
FM 665131
Start
Locked
Do Not Over Tighten
B
A
B
A
TH
Note: If fitting a “True Handleless” kitchen, some components will differ to those shown in this instruction and will also be packaged separately.
Please refer to your True Handleless guide to Receiving for further details on the different components and difference in installation.
