Cambium Networks PTP 850E, Руководство пользователя

Страница: 74 / 560

Chapter 2: Getting Started Configuring the Radio Parameters
phn-3963_008v000
Page 2-31
Configuring the Radio Parameters
In order to establish a radio link, you must:
1. Verify that the radio is muted (the TX Mute Status should be On ).
2. Configure the radio frequencies.
Note:
Even if you are using the default frequencies, it is mandatory to actually
configure the frequencies.
3. Configure the TX level.
4. Click Apply to apply these configurations.
Note:
If you are using the default values and did not change any other parameters
on the Radio Parameters page, the
Apply
button will be grayed out. To
activate the
Apply
button, change any parameter on the page, then change it
back to the desired value.
5. Set TX Mute to Unmute .
6. Click Apply to apply the unmute.
7. Verify that the radio is unmuted (the TX Mute Status should be Off ).
You can do these tasks, perform other radio configuration tasks, and display the radio parameters in the Radio
Parameters page.
To configure the radio parameters:
1.
Select Radio > Radio Parameters . The Radio Parameters page opens.