Cambium Networks PTP 850E, Руководство пользователя

Страница: 55 / 560

Chapter 2: Getting Started Configuring In-Band Management
phn-3963_008v000
Page 2-12
Configuring In-Band Management
You can configure in-band management in order to manage the unit remotely via its radio and/or Ethernet
interfaces.
Note
Before configuring in-band management, it is recommended to review the configuration
recommendations for in-band management listed in

Configuration Tips

.
Each PTP 850E unit includes a pre-defined management service with Service ID 1025. The management service is a
multipoint service that connects the two local management ports and the network element host CPU in a single
service. In order to enable in-band management, you must add at least one service point to the management
service, in the direction of the remote site or sites from which you want to access the unit for management.
Note
In order to use in-band management, it must be supported on the external switch.
For instructions on adding service points, see Configuring Service Points .
After adding service points, you must enable in-band management. To enable in-band management:
1. Select Platform > Management > Networking > Local . The Local Networking Configuration page opens.
Figure 15
Local Networking Configuration Page – In-Band Management
2. In the In-Band Admin field, select Enable .
3. Click Apply underneath the In-Band Admin field.