Chapter 16: Quality of Service (QoS) (CLI)
Displaying Egress Statistics (CLI)
phn-3963_008v000
Page 16-47
Displaying Egress Statistics (CLI)
PTP 850 collects egress PMs at the queue level and the service bundle level.
Displaying Queue-Level PMs (CLI)
PTP 850 supports the following counters per queue at the queue level:
•
Transmitted Green Packets (64 bits counter)
•
Transmitted Green Bytes (64 bits counter)
•
Transmitted Green Bits per Second (32 bits counter)
•
Dropped Green Packets (64 bits counter)
•
Dropped Green Bytes (64 bits counter)
•
Transmitted Yellow Packets (64 bits counter)
•
Transmitted Yellow Bytes (64 bits counter)
•
Transmitted Yellow Bits per Second (32 bits counter)
•
Dropped Yellow Packets (64 bits counter)
•
Dropped Yellow Bytes (64 bits counter)
To display queue-level PMs, enter interface view for the interface and enter the following command:
eth type eth [x/x]> tm-queue show statistics service-bundle-id <service-
bundle-id> cos <cos> clear-on-read <clear-on-read> layer-1 <layer-1>
To clear queue-level PMs for a specific service bundle, enter interface view for the interface and enter the
following command:
eth type eth [x/x]> tm-queue clear statistics service-bundle-id <service-
bundle-id>
Table 157
Egress Queue Level PMs CLI Parameters
Parameter
Input Type
Permitted
Values
Description
service-
bundle-id
Number
1 – 63
Note
: In the
current
release, only
Service
Bundle 1 is
supported.
The service bundle for which you want to display
PMs.
cos
Number
0 - 7
The queue for which you want to display PMs.
clear-on-read Boolean
yes
no
If you enter yes, the statistics are cleared once you
display them.
Содержание PTP 850E
Страница 1: ...User Guide PTP 850E System Release 10 9 ...
Страница 48: ...Chapter 2 Getting Started PC Setup phn 3963_008v000 Page 2 5 Figure 10 Internet Protocol Properties Window ...
Страница 502: ...Chapter 19 Alarm Management and Troubleshooting CLI Performing Diagnostics CLI phn 3963_008v000 Page 19 29 ...