Chapter 16: Quality of Service (QoS) (CLI)
Configuring Policers (Rate Metering) (CLI)
phn-3963_008v000
Page 16-21
Table 135
Assigning Rate Meter for Multicast Traffic CLI Parameters
Parameter
Input Type
Permitted Values
Description
admin-state
Variable
enable
disable
Enables or disables rate metering on
multicast traffic flows from the logical
interface.
profile-id
Number
1 – 250
Select from the rate meter profiles
defined in the system.
The following command assigns Rate Meter Profile 1 to multicast traffic on GbE 1, and enables rate metering on
the port.
eth type eth [1/1]>rate-meter multicast add capability admin-state enable
profile-id 1
The following command changes the rate meter (policer) profile for multicast traffic on GbE 1 to 4:
eth type eth [1/1]>rate-meter multicast edit admin-state enable profile-
id 4
Assigning a Rate Meter (Policer) for Unknown Multicast Traffic (CLI)
Unknown multicast packets are multicast packets with unknown destination MAC addresses. To assign a rate
meter (policer) profile for unknown multicast traffic to the interface, go to interface view for the interface and
enter the following command:
eth type eth [1/x]>rate-meter unknown-multicast add capability admin-
state <admin-state> profile-id <profile-id>
To change the rate meter (policer) profile for multicast traffic, go to interface view for the interface and enter the
following command:
eth type eth [1/x]>rate-meter unknown-multicast edit admin-state <admin-
state> profile-id <profile-id>
To display the current multicast rate meter (policer) profile for an interface, go to interface view for the interface
and enter the following command:
eth type eth [1/x]>rate-meter unknown-multicast show configuration
To delete the rate meter (policer) profile for multicast traffic, go to interface view for the interface and enter the
following command:
eth type eth [1/x]>rate-meter unknown-multicast delete
Table 136: Assigning Rate Meter for Multicast Traffic CLI Parameters
Parameter
Input Type Permitted Values Description
admin-state
Variable
enable
disable
Enables or disables rate metering on
unknown multicast traffic flows from the
logical interface.
profile-id
Number
1 – 250
Select from the rate meter profiles defined in
the system.
The following command assigns Rate Meter Profile 1 to unknown multicast traffic on Eth 7, and enables rate
metering on the port.
Содержание PTP 850E
Страница 1: ...User Guide PTP 850E System Release 10 9 ...
Страница 48: ...Chapter 2 Getting Started PC Setup phn 3963_008v000 Page 2 5 Figure 10 Internet Protocol Properties Window ...
Страница 502: ...Chapter 19 Alarm Management and Troubleshooting CLI Performing Diagnostics CLI phn 3963_008v000 Page 19 29 ...