Cambium Networks PTP 850E, Руководство пользователя

Страница: 365 / 560

Chapter 15: Ethernet Services and Interfaces (CLI) Configuring Ethernet Services (CLI)
phn-3963_008v000
Page 15-21
Table 96 S-VLAN CoS Preservation CLI Parameters
Parameter Input Type Permitted Values Description
sp-id Number 1-32 for P2P and
MP services.
1-30 for MNG
services. The Service Point ID.
s-vlan cos
preservation
mode
Variable enable
disable
Select enable or disable to determine whether the
original S-VLAN CoS value is preserved or restored
for frames egressing the service point.
enable - the S-VLAN CoS value of frames egressing
the service point is the same as the value when the
frame entered the service.
disable - the S-VLAN CoS value of frames egressing
the service point is set at whatever value might
have been re-assigned by the interface, service
point, or service, or whatever value results from
marking (see
Configuring Marking (CLI) ).
The following command enables S-VLAN CoS preservation for Service Point 1 on Service 37:
service[37]>sp svlan-cos-preservation-mode set spid 1 mode enable
The following command disables S-VLAN CoS preservation for Service Point 1 on Service 37:
service[37]>sp svlan-cos-preservation-mode set spid 1 mode disable
Configuring Service Bundles (CLI)
You can use service bundles to personalize common sets of egress queue attributes that can be applied to multiple
service points. In this version only one service bundle is supported.
To assign a service point to a service bundle, go to service view for the service and enter the following command:
service[SID]>sp egress-service-bundle set spid 1 service-bundle-id
<service-bundle-id>