Cambium Networks PTP 850E, Руководство пользователя

Страница: 361 / 560

Chapter 15: Ethernet Services and Interfaces (CLI) Configuring Ethernet Services (CLI)
phn-3963_008v000
Page 15-17
The following command allows frames with a broadcast destination MAC address to ingress Service 37 via Service
Point 1.
service[37]>sp broadcast set spid 1 state allow
The following command prevents frames with a broadcast destination MAC address from ingressing Service 37 via
Service Point 1.
service[37]>sp broadcast set spid 1 state disable
CoS Preservation and Modification on a Service Point (CLI)
The CoS of frames traversing a service can be modified on the logical interface, service point, and service level. The
service point can override the CoS decision made at the interface level. The service, in turn, can modify the CoS
decision made at the service point level.
To determine whether the service point modifies CoS decisions made at the interface level, go to service view for
the service and enter the following command:
service[SID]> sp cos-mode set spid <sp-id> mode <cos mode>
If you set cos-mode to
sp-def-cos
, you must then configure a default CoS. This CoS is applied to frames that
ingress the service point, but can be overwritten at the service level.
To configure the default CoS, go to service view for the service and enter the following command:
service[SID]>sp sp-def-cos set spid <sp-id> cos <cos>
Table 92 Service Point CoS Preservation CLI Parameters
Parameter Input Type Permitted Values Description
sp-id Number 1-32 for P2P and
MP services.
1-30 for MNG
services. The Service Point ID.
cos mode Variable sp-def-cos
interface-decision sp-def-cos - The service point re-defines the CoS of
frames that pass through the service point,
according to the Default CoS (below). This decision
can be overwritten on the service level.
interface-decision - The service point preserves the
CoS decision made at the interface level. This
decision can still be overwritten at the service
level.
cos Number 0 – 7 If cos-mode is sp-def-cos, this is the CoS assigned
to frames that pass through the service point. This
decision can be overwritten on the service level.
The following commands configure Service Point 1 in Service 37 to apply a CoS value of 5 to frames that ingress the
service point:
service[37]>sp cos-mode set spid 1 mode sp-def-cos
service[37]>sp sp-def-cos set spid 1 cos 5