Cambium Networks PTP 850E, Руководство пользователя, Страница: 296 / 560

Chapter 12: Getting Started (CLI) Enabling the Interfaces (CLI)
phn-3963_008v000
Page 12-13
Enabling the Interfaces (CLI)
By default:
•
Ethernet traffic interfaces are disabled and must be manually enabled.
• The Ethernet management interface is enabled.
•
Radio interfaces are enabled.
Note
In release 10.6, only Ethernet Slot 1, Port 7 is supported, along with the radio and management
interfaces. In release 10.9, Ethernet Slot 1, Ports 3 through 7 are supported.
The QSFP port (Port 4), is displayed as follows.
• In a 4x1/10G configuration the QSFP port can provide four Ethernet interfaces: Eth3, Eth4, Eth 5, and Eth6. In
this configuration, a QSFP transceiver is attached to the QSFP port, and an MPO-MPO cable is connected
between the transceiver and a splitter on the other side of the link. The splitter splits the traffic between four
Ethernet cables connecting the splitter to the customer equipment.
To enable or disable an interface, enter the following command in root view:
root> platform if-manager set interface-type <interface-type> slot <slot>
port <port> admin <admin>
To display the status of all the interfaces in the unit, enter the following command in root view:
root> platform if-manager show interfaces
Table 54 Interface Configuration CLI Parameters
Parameter Input Type Permitted Values Description
interface-type Variable ethernet
radio ethernet – an Ethernet
traffic interface.
radio – a radio interface.
slot Number Ethernet: 1
Radio in PTP 850E or PTP 850E: 2 The slot on which the
interface is located.
port Number GbE 1: 1
GbE 2: 2
GbE 3: 3
Radio Carrier 1: 1
Radio Carrier 2 (PTP 850E only): 2 The specific interface you
want to enable or disable.
admin Variable up
down Enter up to enable the
interface or down to disable
the interface.