Cambium Networks PTP 820 Series, Руководство пользователя

Страница: 443 / 1149

Chapter 7: Quality of Service (QoS) Configuring Egress Shaping
phn-3965_006v002
Page 7-32
4. Optionally, in the Description field, enter a description of the profile.
5. In the CIR field, enter the Committed Information Rate (CIR) assigned to the profile, in bits per second.
Permitted values are:
o
0 – 32,000,000 bps, with granularity of 16,000.
o
32,000,000 – 1,000,000,000 bps, with granularity of 64,000.
6. In the PIR field, enter the Peak Information Rate (PIR) assigned to the profile, in bits per second. Permitted
values are:
o
16,000 – 32,000,000 bps, with granularity of 16,000.
o
32,000,000 – 1,000,000,000 bps, with granularity of 64,000.
7. Click Apply , then Close .
Editing a Service Bundle Shaper Profile
To edit a service bundle shaper profile:
1. Select Ethernet > QoS > Shaper > Service Bundle Profiles . The Service Bundle Shaper Profile page opens
( Figure 240 ).
2. Select the profile you want to edit and click Edit . The Service Bundle Shaper Profile – Edit page opens. This
page is similar to the Service Bundle Shaper Profile – Add page ( Figure 241 ). You can edit any parameter
except the Profile ID .
3. Modify the profile.
4. Click Apply , then Close .
Deleting a Service Bundle Shaper Profile
You cannot delete a service bundle shaper profile that is assigned to a service bundle. You must first remove the
profile from the service bundle, then delete the profile.
To delete a service bundle shaper profile, select the profile in the Service Bundle Shaper Profiles Configuration
table (
Figure 240 ) and click Delete . The profile is deleted.
To delete multiple service bundle shaper profiles:
1. Select the profiles in the Service Bundle Shaper Profiles Configuration table or select all the profiles by
selecting the check box in the top row.
2. Click Delete . The profiles are deleted.
Assigning a Queue Shaper Profile to a Queue
To assign a queue shaper profile to a queue:
1. Select Ethernet > Interfaces > Logical Interfaces . The Logical Interfaces page opens ( Figure 214 ).
2. Select an interface in the Ethernet Logical Port Configuration table and click Shaper . The Logical Interfaces –
Shaper page opens, with the Egress Queue Shaper Configuration table open by default. All queue shaper
profiles defined in the system are listed in the table.
Figure 242 Logical Interfaces – Shaper – Egress Queue Shaper