Cambium Networks PTP 820 Series, Руководство пользователя

Страница: 378 / 1149

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Service(s)
phn-3965_006v002
Page 6-7
1. Select Ethernet > Services . The Ethernet Services page opens ( Figure 189 ).
2. Select the services in the Ethernet Services Configuration table, or select all the services by selecting the check
box in the top row.
o
To enable the selected services, in the Multiple Selection Operation section underneath the Ethernet
Services Configuration Table, select Operational and click Apply .
o
To disable the selected services, in the Multiple Selection Operation section underneath the Ethernet
Services Configuration Table, select Reserved and click Apply .
o
To delete the selected services, select Delete underneath the Ethernet Services Configuration Table.
Before deleting a service, you must delete any service points attached to the service, as described in
Deleting a Service Point .
Figure 191 Multiple Selection Operation Section (Ethernet Services)
Note
When setting multiple services to Reserve state, make sure to avoid setting the management service
to Reserve state.
Viewing Service Details
To view the full service parameters:
1. Select Ethernet > Services . The Ethernet Services page opens ( Figure 189 ).
2. Select the service in the Ethernet Services Configuration table.
3. In the Ethernet Services page, click Service Details . The Ethernet Services – Service Details page opens. The
Service Details page contains the same fields as the Add page ( Figure 189 ). However, in the Service Details
page, these fields are read-only.