Cambium Networks PTP 820 Series, Руководство пользователя, Страница: 376 / 1149

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Service(s)
phn-3965_006v002
Page 6-5
Figure 190 Ethernet Services - Add page
3. In the Service ID field, select a unique ID for the service. You can choose from any unused value from 1 to
1024. Once you have added the service, you cannot change the Service ID. Service ID 1025 is reserved for a
pre-defined management service.
4. In the Service Type field, select the service type:
o
MP – Multipoint
o
MNG – Management
o
P2P – Point-to-Point
5. Optionally, in the EVC ID field, enter an Ethernet Virtual Connection (EVC) ID (up to 20 characters). This
parameter does not affect the network element’s behavior, but is used by the NMS for topology
management.
6. Optionally, in the EVC Description field, enter a text description of the service (up to 64 characters). This
parameter does not affec t the network element’s behavior, but is used by the NMS for topology
management.
7. In the Admin field, select one of the following options:
o
Operational - The service is functional.
o
Reserved - The service is disabled until this parameter is changed to Operational . In this mode, the service
occupies system resources but is unable to receive and transmit data.
8. In the MAC table size field, enter the maximum MAC address table size for the service. The MAC address
table is a source MAC address learning table used to forward frames from one service point to another. You
can select a value from 16 to 131,072, in multiples of 16. This maximum only applies to dynamic, not static,
MAC address table entries.