Calrec BRIO 36, Руководство пользователя

Страница: 138 / 210

138 BRIO 36
Audio Production System with Optional Networking
PROCESSING
Assigning AutoFaders to faders
Once the relevant GPIs have been assigned to AutoFaders, the AutoFaders can be assigned to control faders on the
surface. This is done on the Access>AutoFader screen as shown in Figure 3.
FIGURE 3 - ASSIGNING AUTOFADERS TO FADERS
AutoFader levels
When an AutoFader is attached to a fader and is enabled, providing the trigger signal is not present, the fader will go to
the OUT LEVEL complying with the Fade-Out Duration parameter, rather than snapping the audio to the Fade-Out level.
If an AutoFader is enabled, either from path or global enable, for a path whose GPI is currently triggered, the audio should
fade (up or down) to the Fade-In Level (if it is not there already), complying with the Fade-In Duration parameter, rather
than snapping the audio to the Fade-In level. When the trigger signal is present, the fader will follow the settings made on
the Access>AutoFader screen.
AutoFader parameter settings
The AUTOFADER screen allows the settings of the AutoFaders to be configured. The available settings for all the Time
based controls are :
• 0 to 100ms in 10ms steps.
• 100ms to 1s in 100ms steps.
• 1s to 5s in 500ms steps.
The IN and OUT gain level settings are -100dB to +10dB.
Global AutoFader Bypass
At the bottom of the AutoFader screen there is a copy of the Global Bypass button which effectively disables all
AutoFaders.
AutoFader indicators
When an AutoFader is assigned to a fader, the Fader display will show the AutoFader Number and the Meter display
shows when the AutoFader is active.