Calrec Artemis, Руководство оператора

Страница: 111 / 196

CALREC
Putting Sound in the Picture
111
OUTPUT PORT PROTECTION
Output port protection is a system
that notifies operators when they
are attempting to patch to outputs
that are already in use by other
people elsewhere on the network,
and provides information to assist in
deciding whether to go ahead with
each patching decision.
All output destinations can be available to
all consoles on a Hydra2 network if they
have been granted access within H2O,
but only one audio feed can be routed to
each individual output at any one time.
When an output is in use, it is “protected”
from over-patching by other users on the
network.
You can always overpatch your own
patches. They are only protected from
being overpatched by someone else.
PatchingtoProtectedOutputs
When an operator patches to a protected
output, either by console patching or by
loading shows, user memory or alias files,
a pop-up appears on the main application
screen containing a table of information to
assist in choosing whether to go through
with the new patching or to keep the
current settings, see Fig 1.
The check boxes down the left hand side
of the table are used to select each patch
change individually. The ‘Select All’ check
box selects and deselects all patching
changes as a whole.
On clicking ‘Accept Changes’, changes
which are checked in the pop-up, plus
any changes which are not displayed due
to them having no effect on protected
outputs are all made and the pop-up
closes.
On clicking ‘Cancel All’ all changes that
affect protected outputs are rejected but
all changes which do not affect protected
outputs are made and the pop-up closes.
If a user memory is loaded from the
surface’s memories panel area when in
monitor mode, a simplified version of the
pop-up is also displayed on the surface
allowing the operator to accept or cancel
all changes, providing output protection
notification on the surface, without
reliance on the system PC.
Always ensure patching changes are
correct before accepting them as
you may affect other users on the
network.
FIG 1 - OUTPUT PROTECTION POP-UP
Output protection differs from local lock
of output ports. Local lock is a manual
process which locks an output for all
operators, whereas output protection is
an automatic process designed to prevent
accidental over-patching during operation,
whilst retaining a smooth workflow.
As detailed in the Input Port Protection
section of this manual, when loading
shows, user memory or Alias files it is
likely that both protected outputs and
shared inputs will be affected by the
memory load. In this case the pop-up
will have two stages - Input Sharing and
Output Protection.