Calrec ARGO, Инструкция по установке и техническому обслуживанию

Страница: 68 / 92

68 ARGO
Digital Broadcast IP Production Console
Panel Options
STANDARD FADER PANEL - IU6576
The IU6576 Standard Fader panels
make up the Argo S/Argo Q fader bed,
multiple panels are fitted to make up
the required fader quantity.
The IU6576 is 378.5mm wide x 322mm
high and is fitted with 12 x 100mm
PANEL CONNECTOR LAYOUT
IU6576 - ARGO S & ARGO Q STANDARD 12 FADER PANEL
throw touch sensitive faders. Each fader
strip also has the following controls/
displays from bottom to top:- Mini TFT
layer display, PFL button, 2 user defined
buttons, Mini TFT meter display, AFL
button, B-Layer button (if required),
Access button, Mini TFT fader display, ON/CUT button which can be software
configured to light when the fader path
is active (ON) or when the fader path
is muted (CUT). The upper area of the
panel has 2 sets of 4 button cells with a
Mini TFT Display per fader which can be
configured to display the various switch
parameters as required.
Connections
This panel has two separate connectors
for power and control placed on the
back of the unit. The Standard Fader
panel connects to the UN6539 section
processor which provides both power via
a 4 pin 12v DC connector and control
data via a USB 3 Type B connector which uses the Superspeed pairs to provide
2 x LVDS outputs on each USB 3.0 port
for Mini-TFT data to the Control Surface
Modules. The USB 2.0 legacy pair in the
USB 3.0 connector transports surface
control events between panels and host
processor.