Calix GigaSpire BLAST u12 GS202xE, Руководство по установке

Страница: 22 / 41

22
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Wall Mounting Dimensions
Dimensions for wall mounting of a GigaSpire BLAST are included here for reference.
GigaSpire Mounted Dimensions Wall Mount Bracket Dimensions
*- Screw length may vary based on
attaching wall material
#8 Mounting Screw*
Not Provided
3.8 in.
96.6 mm
8095
Type M6 Captive
Mounting Screw
11.6 in.
294.9 mm
8096
8.4 in.
292.5 mm
(Maximum Distance)
8094
4.98 in.
126.6 mm
(Provided in Bracket Kit)
Note: 2-pin or 8-pin power adapter is 4.9" (1.5m) long.
Tabletop Mounting the GigaSpire BLAST
Any Calix GigaSpire BLAST can be mounted flat on a tabletop, in a tower configuration.
Four (4) rubberized feet are pre-installed on the bottom of the unit to provide a non-skid
surface when placing the GigaSpire on a table or shelf.
Keep the following information in mind when considering tabletop mounting:

Due to component placement inside the chassis, do not remove the rubber feet that are
installed on the bottom of the unit. Locate the GigaSpire on the desktop in a location
that is unlikely to be bumped or jostled.
 Make sure that the Ethernet cable (if used) and power supply wiring attached to the
GigaSpire are secured properly and out of harms way.
Note: The wall mount bracket is available separately and applies to all u6 and u12 BLAST
products.
Note: Once the GigaSpire is connected and turned up, Wi-Fi network parameters are
persisted in memory. For this reason, if power is lost to the GigaSpire, it will be re-
discovered on the network automatically, without operator intervention.