California Instruments 3000iL, Руководство пользователя

Страница: 77 / 100

iL Series User Manual
California Instruments
Rev B 67
6.4.3 Changing the Calibration Password
The factory default calibration password is 0. You can change the password when the
AC source is in calibration mode (which requires you to enter the existing password).
Proceed as follows:
Step Action Display
1. Begin by pressing Shift Calibration and scrolling to the
CAL ON command.
CAL ON 0.0
2. Enter the existing password from Entry keypad and press
Enter
3. Press Shift Calibration and scroll to the CAL PASS
command
CAL:PASS 0
4. Enter the new password from the keypad. You can use
any number with up to six digits and an optional decimal
point.
Table 43 : Changing the calibration password
Note: If you want the calibration function to operate without requiring any
password, change the password to 0 (zero).
6.4.4 Calibration Error Messages
Errors that can occur during calibration are shown in the following table.
Error no. Error Meaning
401 CAL switch prevents calibration
1
402 CAL password is incorrect
403 CAL mode is not enabled
404 Computed readback CAL constants are incorrect
405 Computed programming CAL constants are incorrect
406 Incorrect sequence of CAL commands
Table 44 : IEEE-488 Calibration Error Messages
1
This is a hardware disable. See section 6.4.4.
6.4.5 Calibration Over the IEEE-488
You can calibrate the AC source by using SCPI commands within your controller
programming statements. Be sure you are familiar with calibration from the front
panel before you calibrate from a controller. Each front panel calibration command
has a corresponding SCPI command.
The SCPI calibration commands are explained in chapter 4 of the AC source
Programming Manual. Calibration error messages that can occur during IEEE-488
calibration are shown in Table 44.