Caliber SCFGPA, Руководство пользователя

Страница: 3 / 34

2. Troubleshooting
2.1 Troubleshooting Table
The Caliber Target System performs two separate functions or sub-systems:
1. Moving the target carrier up and down the range
2. Turning the target and turning on the lights
In most cases, a problem with one sub-system should not affect the other.
Note: The first 4 symptoms describe popups that would appear on the local Screen. If you
don’t see a popup, it was probably cleared by someone but the problem may still exist.
Symptom Possible cause Section
The target will not turn and may
be stuck at an odd angle and the
target carrier lights will not go on Damaged Bus Bar insulator
or Bus screws. Frayed
aircraft cable shorting to
the Bus Bar. Dirt buildup
on the Bus. Short inside the
Target Carrier.
2.2 Bus Short Error (popup)
The Carrier has stalled on the
dead stop at the drive unit Home switch problem 2.3 Lane Home Switch Error
(popup)
The target carrier cannot reach
the position it was commanded to
go to Damaged track
Frayed aircraft cable
Bad encoder 2.4 Local Travel Error (popup)
Master Control lost contact with
one of the Lanes Unplugged or bad Cat6
cable 2.5 Communications Error (Master
Screen only)
(popup)
Target does not respond to move
commands Motor VFD in error
Bad Drive Motor
Aircraft cable bad
2.6 Resetting the Drive Unit
Targets become unresponsive
from the Master Control Screen
only Master Control CPU error 2.7 Resetting the Master CPU
Targets become unresponsive
from action shooting. Uncompleted Drills 2.8 Resetting Drills hang-ups
Problems with lights and strobes Dirty bus bar
User misunderstanding 2.9 Lights and strobes