The table below summarises the beacon receiver's specifications:
RF Specification
Input frequency range
950 to 2050 MHz
Frequency Step Size
1 KHz
L-Band Input Connector
SMA female 50 Ohm
LNC voltage
OFF/14/18V
L-Band Test Output Connector
SMA female 50 Ohm
Input Noise Figure
< 10dB
Frequency accuracy
1*E-6
Input Level measurement range
-40 dBm to -80 dBm
Measurement bandwidths
6, 12, 30 and 100 KHz
Minimum C/N0 (6kHz)
45 dBHz
Output Voltage range of analogue AGC voltage
0V to 10V
Slope of analog output voltage
programmable, -5.0 .. +5.0 V/dB
0V point of analog output voltage
programmable, -200 to 0 dBm
Output Connector for analog output voltage
SMA female
Linearity failure
+/-1dB in any 10 dB
Switchable input attenuator to adapt the dynamic
range and input signal level
0, 10, 20, 30 dB
Video bandwidth selectable by micro controller
0.1 Hz, 0.5 Hz, 1 Hz, 5 Hz, 10Hz, 50 Hz, 100 Hz
Large signal behaviour
no impact at -35dBm total input power
M&C Interface Specification
RS232 M&C Interface
D-SUB 9 female
RS422 level information TX-only
D-SUB 9 female
Summary fault indication
Photo MOS relay contact D-SUB 9 male (120 V
D/C, 100 mA)
Level alarm indication
Photo MOS relay contact D-SUB 9 male (120 V
D/C, 100 mA)
Electrical
and
Mechanical
Specification,
Environmental conditions
Supply Voltage
22 V to 28 V unregulated D/C (25V for 2050
MHz) 0.35A without LNB
Temperature range
-25° to +55° C operational, -40° to +70° C storage
temperature
Humidity
up to 90% non condensing
DIN rail module
270 x 105 x 50 mm
(C) 2020, SatService GmbH
www.satnms.com
LBRX-1MT-UM-2002 Page 20/21
