#9 Viper_SC_Manual_
001-5008-000_Rev12e.docx |
Page 33
4.3.2
IP SETTINGS
Figure 22 – Setup(Basic)
IP Settings
4.3.2.1
ETHERNET INTERFACE
―
DHCP Client.
Select
Static
/
Dynamic
.
Default = Static.
Select
Static
to
enable user entry of IP address of the unit. Select
Dynamic
to set the unit to be a DHCP client, which will allow the unit to accept an IP address from an external DHCP
server. Activating this option will reset the IP address of the unit. If your network supports the DHCP Server capability,
make sure the IP address assigned by the DHCP server will be accessible to you. If your network does not support DHCP
server capability, the unit will be reset to the default (192.168.205.1) IP address.
―
IP Address.
Default =
192.168.205.1
). Set a valid unique
IP address
and
Netmask.
(Default =
255.255.255.0
). for each
Viper in the network. In Bridge mode, all the Viper SCs must be configured for the same IP subnet; in Router mode,
each Viper SC must be configured for a unique subnet.
―
DHCP (Dynamic Host Configuration Protocol) Server.
Select
Enabled/Disabled
.
Default = Enabled.
DHCP provides a
framework for passing configuration information. E.g.: Assigns IP address to Hosts (i.e. PC/RTU) on a TCP/IP network.
Requires
Start Address
,
Number of Leases
,
Lease Duration
(in minutes, where 0=Infinite), and
Gateway
.
Содержание Viper 100
Страница 42: ...9 Viper_SC_Manual_001 5008 000_Rev12e docx Page 35 Figure 23 Setup Basic Channel Table...
Страница 44: ...9 Viper_SC_Manual_001 5008 000_Rev12e docx Page 37...
Страница 103: ......
