CalAmp Viper 100, Руководство пользователя

Страница: 34 / 115

#9 Viper_SC_Manual_
001-5008-000_Rev12e.docx |
Page 27
― Apply. Use this command to write to RAM. When making an entry into a dialog box, click Apply when you are satisfied
with the changes to temporarily apply the value(s) entered to the relevant parameter(s). Failure to use this command
before leaving a web page will result in the loss of entered selections, addresses, and values.
― Cancel. This command only affects the dialog boxes or radio buttons in the opened window.
4.1 UNIT STATUS
From the navigation frame, select Unit Status to display General and Diagnostic data for the device.
4.1.1 GENERAL
The Identification and Status banner displays the software revision information (Ex. Vx.y_Rxxx). Vx.y is revision number,
and Rxxx represents the Package Release Build Number.
Figure 18 – Unit Identification and Status
― Station Name. Displays the name of the connected unit.
― Local Time. Displays time zone configuration using UTC time and the selected Time Zone. Unless an SNTP server is
configured, this parameter will be restored to the factory default when device power is cycled. An SNTP server can be
configured in
Section 4.4.6 .
― CWID. Display only. Continuous Wave Identification (CWID) is configured in Section 4.3.1.1 .