Cajun P220G, Руководство по конфигурации и эксплуатации

Страница: 54 / 135

Using VLANs, Spanning Tree, and Hunt Groups
Cajun P220G Switch Configuratiion and Operation Guide 3-17
# )& ' 0
To configure a hunt group on the embedded server, complete the following steps:
1. Make sure the same-speed ports that you are configuring into a hunt group are
physically connected to each other (for example, in a four-port gigabit hunt group,
make sure you have four fiber cables with P220G switch ports connected at each
end).
2. Disable all of the ports you are adding to the hunt group if this is a new hunt group.
If you are adding ports to an existing hunt group, disable the ports you are adding.
Note: To disable the ports, complete the following steps:
a. Select Physical Ports from the menu on the left side of the Web Agent.
b. Uncheck Enable.
c. Click APPLY.
3. Select Hunt Groups from the menu on the left side of the Web Agent on the first
switch. The first Hunt Group Configuration screen displays (Figure 3-12). This
screen supports the features described in Table 3-7. Table 3-8 lists the hunt group
parameters.
Figure 3-12. First Hunt Group Configuration Screen