!
WARNING:
There may be
some residual
HOT
WATER
within
the capsule area.
Stand to the side of
the machine when
opening the lever.
Cycle water
through the system
by pressing the
Double Espresso
button after
dispensing a coffee
or other
hot beverage.
17.
TIP:
The quantities of beverage dispensed can be programmed. Please refer
to chapter “Programming the quantity of coffee in a cup” in your Manual.
FIRST TIME USE
MODEL
S06HS QUICK START GUIDE:
C O M P A T I B L E W I T H C A P S U L E R A N G E S F R O M
For more information visit our website:
www.caffitalysystem.com.au
Diagram 1
Tea Button -
120ml (Lit Blue)
WARNING: Only use tea button for tea.
Single Espresso Button
30ml (Lit White)
Double Espresso Button
60ml (Lit White)
Indicator Light
(Orange=Descale | Red=Check System)
Place a large
empty container
(at least 250 ml)
under the coffee
dispensing spout.
5.
Press the Double
Espresso button.
The machine will
draw water through
the system (Approx.
30 sec.). When
done, the indicator
light will switch off.
6.
Fill the tank with
fresh, still water
(either by filling
through the
water tank cover
or removing
the water tank).
1.
Plug in
appliance.
Switch machine
on using the
On/Off Switch
.
2.
ON
Along with the
button lights,
the indicator
light will also
blink
RED
.
4.
Make sure the
lever is closed.
*Ensure there
is no capsule in
machine.
3.
WARNING:
During the priming
and rinsing stage,
HOT WATER
will
be collected in
the used capsule
drawer.
Danger of
scalding.
!
When all the
button lights
remain steadily lit,
rinse by pressing
the Double
Espresso button.
Press again to
repeat cycle.
8.
7.
Once successfully
primed, all the
button lights will
continue to blink
while the machine
is warming up
(
Approx.
1 min.).
i
NOTE:
If the
buttons and the
indicator light
continue to blink
and no water has
been extracted,
repeat Step 6.
10.
When all the
button lights are
lit steadily, the
machine is ready
to use.
At the end of this
operation, raise
the lever and
carefully remove
the used capsule
drawer. Empty
the water, rinse
and replace.
9.
Insert the
capsule,
pressing it
gently into
place.
12.
Raise the lever to
open the capsule
compartment.
11.
Close the lever
fully and place
a cup or mug
under the coffee
dispensing spout.
13.
Press and release
the button
corresponding
to the type of
beverage you want
as per
DIAGRAM 1
above.
14.
15.
The selected
beverage button
will blink and
machine will stop
dispensing on
reaching the
programmed
quantity.
Gently raise the
lever to eject the
used capsule
into the drawer
and then close
the lever.
16.
For instructions on frothing or
steaming milk using the Steam Wand,
please refer to the Product Manual.
ONLY USE WITH
Caffitaly System
Capsules
S06_QuickGuide_07_FA.indd 1
2014/07/31 2:08 PM
