TOTAL LITE Revision 1
SERVICE MANUAL FOR INNOVATION
TOTAL LITE
Single-Cup Brewer
26
6.6.3 Brew cycle tab
There are four different brew cycles in the TOTAL LITE. The brew cycle is automatically selected
depending on water level in the coffee recipe.
For brewer water quantities equal or bellow 100 units, Cycle #4 will be selected. It is a quick cycle for low
water levels.
For brewer water quantities between 101 and 187 units,Cycle #1 will be selected. It is the regular Avalon
brew cycle.
For brewer water quantities between 188 and 269 units, Cycle #2 will be selected. It is a 3 swirling cycle.
Water volume is high and coffee quantity must be also high. Water is dispensed in 3 shots in the brewer
and the coffee-water mix is swirled 3 times to make sure the all coffee is in contact with the water.
For brewer water quantities of 270 and higher, the double brew cycle #3 is selected. The coffee machine
will split in half the water and ingredient quantity and do two brew cycles.
Extra grind time : The amount of time the grinder is activated to grind all the beans depends on the
amount of coffee beans set and is calculated by the computer. If the grinder is aged and does not grind all
the beans you can add some extra grind time via this box. The default setting is 0.
20 units = 1 second.
Pause 1 : One of the contact time of water and coffee. If you want more extraction, increase this time.
20 units = 1 second.
Pause 2 : Another contact time of water and coffee. If you want more extraction, increase this time.
20 units = 1 second.
Move 3 : Brewer motor moving time. A brewer position setting. It is the position where the brewer piston
stops before restarting to dispense into the cup.
If this setting is too high, the brewer piston goes too far down, prematurly opening the top brew chamber,
causing a mess of wet coffee grinds inside.
If this setting is too low, the brewer piston does not move down far enough, not pulling all the coffee
through the filter.
Change this setting with caution.
Pause 3 : Pause before the top brew chamber opens and the coffee is dispensed into the drink. If you
have wet coffee grinds on the filter paper at the end of the brew, increasing this setting might solve the
problem. 20 units = 1 second.
Pause 4 : The brewer drain time. Must be high enough to empty the brewer at the end of the cycle.
20 units = 1 second.
There are no individual cycle table for each drink. There is one cycle table for all the drinks.
Service Software
