INNOVATION Total 1 Rev 8 06/2013
www.cafection.com
(800) 561-6162
62
INSTALLATION AND SERVICE MANUAL FOR INNOVATION
Total 1
Bean-Cup Brewer
Servincing Parts
7.2
Shutdown / Storage
Should you need to store this brewing equipment for an extended period of time, follow this procedure to
avoid any risk of injury or damage to the equipment.
1. Turn the unit off and unplug form the power outlet;
2. Drain the hot water tank (see instructions in section 7.1);
3. Empty the soluble canisters and the 3 bean canister;
4. Clean all parts of the unit before storing (see cleaning instructions in section 5)
5. Disconnect the white double wire from the heating element (see installation diagram in section 6.3)
6.
Tie down the water level switch’s arm with a “tie-wrap” to keep the float from pulling down on the
switch during transportation. “
Do not overtighten
”, this may damage the switch; this is simply to keep the
float from bouncing up and down on the switch.
7.2.1 Storing the Platinum Brewer
The brewer is the heart of equipment and is responsible for the good taste of each cup of coffee. It is
therefore important that you store it properly when it is not in the brewer. Always disengage your brewer
clutch by using a pair of pliers and turning the pin located on the back clockwise until the brew chamber
lifts up. This will release the pressure on the screen and seal. Your brewer must be on its back or its left
side while on a table top. Do not sit the brewer on its right side (wheels and yoke) or straight up as
these positions are not sturdy and could cause it to fall.
