INNOVATION Total 1 Rev 8 06/2013
www.cafection.com
(800) 561-6162
38
INSTALLATION AND SERVICE MANUAL FOR INNOVATION
Total 1
Bean-Cup Brewer
Service Software
Move 3 : Brewer motor moving time. A brewer position setting. It is the position where the brewer piston
stops before restarting to dispense into the cup.
If this setting is too high, the brewer piston goes too far down, prematurly opening the top brew chamber,
causing a mess of wet coffee grinds inside.
If this setting is too low, the brewer piston does not move down far enough, not pulling all the coffee
through the filter.
Change this setting with caution.
Pause 3 : Pause before the top brew chamber opens and the coffee is dispensed into the drink. If you
have wet coffee grinds on the filter paper at the end of the brew, increasing this setting might solve the
problem. 20 units = 1 second.
Pause 4 : The brewer drain time. Must be high enough to empty the brewer at the end of the cycle.
20 units = 1 second.
There are no individual cycle table for each drink. There is one cycle table for all the drinks.
1. Brings back all brew cycles setting to factory settings.
2. TO SAVE any parameters change press this button.
1.
2.
Please contact Technical Support for the whole
information about our Service Software
1 800 561-6162
