Caen RFID skID, Техническое руководство

Страница: 38 / 105

CONFIGURATION MENU - skID Technical Information Manual 38

TARGET: two options available, A or B. For more information on TARGET parameter refer to EPC
Class1 Gen2 protocol specification [RD1]. Default value is TARGET = A. You can change the default
value using the drop-down menu.

SELECTED: three options available, ALL/NOT selected/selected. For more information on
SELECTED parameter refer to EPC Class1 Gen2 protocol specification [RD1]. Default value is
SELECTED = ALL. You can change the default value using the drop-down menu
When the reader is configured in the EASY2READ profile, to set the EPCC1G2 Parameters you can also use
the CAEN RFID Easy Controller Application or the SDK (Software Development Kit) library. Note that
using the SDK or the Easy Controller only the current values are set, therefore when the reader is turned
off, the parameters assume the values set via the configuration interface again.
Warning: To save the changes click on the SAVE button (check the green dot on the bottom
right side of the sidebar). On the main application window click on File  Disconnect . Power off
the reader, disconnect the USB cable and then power on the reader, the new settings are
active.
EASY2READ Parameters
Choosing the EASY2READ profile, the EASY2READ parameters available are:

TID Length: TID Length is an editable field and represents the length of the TID memory to be
read during the inventory, expressed in bytes. The default value is 12, accepted values are
included in the range 0÷64.

Read Cycles: Read cycles is an editable field and represents the number of read cycles performed
by the logical source during the inventory algorithm execution. The default value is 1. Read cycles
= 0 means no stop in the continuous inventory mode. Note that Read Cycles affects only
inventory performed with continuous mode.