Caen RFID R1280I, Техническое руководство, Страница: 16 / 83

CONFIGURATION MENU - skID Technical Information Manual 16
Note that, when the reader is configured in the EASY2READ profile, to set the EPCC1G2 Parameters you
can also use the CAEN RFID Easy Controller Application or the SDK (Software Development Kit) library.
Y
Warning: To save the changes click on the SAVE button (check the green dot on the bottom
right side of the sidebar). On the main application window click on File

Disconnect . Power off
the reader, disconnect the USB cable and then power on the reader, the new settings are active.
EASY2READ Parameters
Choosing the EASY2READ profile, the EASY2READ parameters available are:

TID Length: TID Length is an editable field and represents the length of the TID memory to be read
during the inventory, expressed in bytes. The default value is 0, accepted values are included in the
range 0÷64.

Read Cycles: Read cycles is an editable field and represents the number of read cycles performed
by the logical source during the inventory algorithm execution. The default value is 0 that means no
stop in the continuous inventory mode. Note that
Read Cycles affects only inventory performed with
continuous mode.
Y
Warning: To save the changes click on the SAVE button (check the green dot on the bottom
right side of the sidebar). On the main application window click on File

Disconnect . Power off
the reader, disconnect the USB cable and then power on the reader, the new settings are active.