Caen RFID Hex R1290I, Техническое руководство

Страница: 21 / 57

CONFIGURATION MENU VIA READER - Hex R1290I Technical Information Manual 21
trigger button to return to the RFID submenu. If the Tag Count is enabled, when the reader performs a tag
inventory, the reader display shows the number of tags read.

Back: select “back” with the up or down button and press the trigger button to return to the RFID menu.
HID opt.
Through the HID opt submenu you can configure the reader when using the HID profile.
The HID options are the following:

RF Power: through the RF Power submenu you can set the start-up power level emitted by the reader. The
display shows the default RF Power. To scroll through the RF Power options, press the trigger button until
the desired RF Power value is shown.
The RF Power value is expressed as a percentage value of the maximum RF output power:

5%

10%

20%

40%

60%

80%

100%
The correspondent values are:
Percentage
Conducted Power
2
(mW)
Radiated Power ETSI
(mW e.r.p.)
Radiated Power FCC
(mW e.r.p.)
5% 25 16 18
10% 50 32 36
20% 100 64 72
40% 200 128 144
60% 300 192 215
80% 400 256 287
100% 500 320 359
Tab. 3.3: Conducted power- radiated power

Trigger Button: through this option, you can enable or disable the tag inventory on trigger button press. The
Trigger Button options are the following :

Enable (one shot): enable the tag inventory at the trigger button press. When the Trigger Button is
enabled (one shot), to perform the tag inventory just hold down the trigger button and then release.
The reader performs a single inventory cycle.

Enable (start/stop): enable the tag inventory at the trigger button press. When the Trigger Button is
enabled (start/stop), to perform the tag inventory just hold down the trigger button and then release.
The reader performs inventory cycles until the trigger button is pressed for the second time (stop).

Disable: disable the tag inventory on trigger button press.
By default, the Trigger Button is disabled. To modify the value, press the trigger buttons until the desired
value is shown (enabled one shot/enabled start stop/disabled), then press the up or down button to select
“back” and the trigger button to return to the HID opt .

Proximity: through this option, you can enable/disable the proximity sensor (see § Fig. 1.2: Hex R1290I Top
Panel page 7). By default, the Proximity Sensor is disabled. To modify the value, press the trigger button
until the desired value is shown (enabled/disabled), then press the up or down button to select “back” and
the trigger button to return to the HID opt . If the Proximity Sensor is enabled, the reader performs a tag
inventory when he perceives a decrease in brightness due to the passage of a tag. Note that the sensor is
also sensitive to the change in brightness due to the turning off of the light or the passage of a shadow.
2
On external antenna