F1K5-DISS – User’s Manual
13
Power Connection
It is recommended to use original cables that are contained with the unit. If
custom longer connection is required keep wire size of main power connection at 16
mm
2
(AWG 6) and not longer than 1m. Strip wires insulation back 15 mm and push
them straight into the power plug and screw them tightly. Be sure that they fit well and
make a good contact.
Connect main power cable to
DISSIPATIVE UNIT
connector on FAST-PS-1K5
and to
FAST-PS-1K5
connector on dissipation unit. Secure cable assembly with
connectors screws on both ends.
Figure 1: “
Power cable” connection
Status Cable Connection
Connect the supplied coaxial cable to
STATUS
BNC connector on F1K5-DISS
side and
AUX2
BNC connector on FAST-PS-1K5 side.
Figure 2: “
Status cable” connection
