7
Changing the Air Volume
Press the air volume button (
).
Air volume and operation mode cannot be configured
simultaneously.
Each time the air volume button is pressed, it makes a beeping
sound and the air volume mode changes.
The indicator of the selected air volume will light up.
Operation continues with the selected air volume.
Selecting the Operation Time
Press the timer button (
).
Each time the timer button is pressed, it makes a beeping
sound and the time setting changes.
The indicator of the selected timer will light up.
1h
4h
8h
Off
The timer setting will be deactivated when the timer is off.
Turning off the Odor and Dust
Monitor and Air Inlet Lamps
Press the light button (
).
If the light button is pressed during operation, there will be a
beeping sound and the odor and dust monitor and air inlet
lamps will turn off.
If the light button is pressed again, the odor and dust monitor
and the air inlet lamps will light up again.
Note
The inlet lamps will not turn off completely even after the light button is
pressed. This light is from the photocatalytic lamp.
How to Operate
Starting the Unit
Plug the power plug into the wall outlet.
All indicators and buttons on the control panel along
with the odor and dust monitor and the air inlet lamps will
momentarily light up then turn off.
Press the power button ( ).
After it beeps, all of the buttons on the control panel along
with the automatic indicator, odor and dust monitor, and the
air inlet lamps will light up.
If the power button is pressed while the unit is still operating, the
lit buttons, indicators, odor and dust monitor, and the air inlet
lamps will turn off and then the unit will stop operating.
Selecting the Operation Mode
Press the mode button (
).
The operation mode and air volume cannot be set simultaneously.
Each time the mode button is pressed, it makes a beeping
sound and the operation mode changes.
The indicator of the selected mode will light up.
About operation mode
Auto-
matic
Normally use this mode.
The room condition is detected with the odor and dust
sensors, and the air volume setting switched between
low, middle, and high.
Eco
Used in situations with low volumes of air pollutants,
such as at night.
Only the power button and eco-mode indicator light up
and the unit operates with low air volume setting. (The
photocatalytic lamp is also off.)
Rapid
Use this mode if you want to quickly clean the air.
The unit operates with an air volume stronger than the
high air volume setting for 2 hours, then changes to
automatic mode.
1
2
Power
button
Mode
button
Air volume
button
Timer
button
Light
button
Air volume indicator
Timer indicator
Mode indicator
Automatic
Eco
High
Middle
Low
Rapid
Illumination intensity sensor
☞
Filter replacement indicator
☞
