360-693-2505
Fax: 360-694-6939
P.O. Box 1675
Vancouver, WA
98668-1675
WARNING!
Take extreme caution when
working with electricity. Turn
off all power at the circuit
panel or fuse box before
doing any electrical wiring.
Lock, tape, or tag the circuit
panel door so power cannot
be turned on during
installation.
Failure to do so
could result in serious injury
or possible fatality!
OWNER’S GUIDE
The Com-Pak
TM
Plus
Keep for future reference
1.
Read all information labels.
Verify that the electrical
supply wires are the same
voltage as the heater.
2.
All electrical work and
materials must comply with
the National Electric Code (NEC), the Occupational
Safety and Health Act (OSHA), and all state and local
codes.
3.
The heater must be grounded to the grounding pigtail
(copper wire) provided in the wall can.
4.
If you need to install a new circuit or need additional
wiring information, consult a qualified electrician.
5.
Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
6. DO NOT
install the heater in a floor, behind doors, towel
racks, drapes, furniture or coat racks, or anywhere the
air discharge may be blocked in any manner.
7. DO NOT
install heater in any area where combustible
vapors, gases, liquids, or excessive lint or dust are
present.
General Safety Information
12"
9"
11 /
1
2
"
10"
1 /
1
4
"
3 /
1
4
"
6 /
7
8
"
3 /
1
4
"
4"
1 /
5
8
" 1 /
1
2
"
The Com-Pak Plus
Model C
The Com-Pak Twin Plus
Model CT
Models: The Com-Pak Plus
C072
C072T
C102
C102T
C122
C122T
C152
C152T
C202
C202T
C208
C208T
C101
C101T
C151
C151T
Models: The Com-Pak Twin Plus
CT302
CT302T
CT402
CT402T
CT408
CT408T
Features & Benefits
■
Wall can designed to fit between two
studs for ease of installation
■
Powder coat paint system eliminates
sharp cutting edges
■
Nichrome element wrapped around mica
insulators for durability – 2 year warranty
■
Model C has two limit switches for safety
and assurance, a manual reset limit and
a back-up shutdown safeguard.
(Model CT is equipped with four limits)
■
Fully tested at factory
■
Made in the U.S.A.
Side
Side
Front
Bottom
Grill
Wall Can
Grill
Wall Can
Side
Side
Front
Tools Required:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Drill or Hammer
Drill Bits
Utility Knife
4 Screws
3 Wire Nuts
1 Strain Relief
Connector
