CAD Lights Aquariums Versa Series, Инструкции

Страница: 2 / 4

4) Using #7,8 place on the left and right sides of the now partially formed bottom of the cabinet. using the CX14 screws, screw in from the
outside into the bottom using the pre-drilled holes
5) using #9 put into place in between #7 and #8 towards the upper front corner, then use C screws to screw in from the outside pre-drilled
holes to fasten into place
6) using #10, flip upside down and use A anchor rods to screw into the pre-drilled holes
7) when A anchor rods are all in place on the underside of the top panel #10 flip upside down and fit into pre-driled holes of the top of the
cabinet
8) using #11 flip upside down and screw in 2 A anchor rods on the pre-drilled holes. then place into the pre-drilled holes of the cabinet. lock
in place using G CAM screws from the inside of the cabinet
9) using the doors #11 and #12 lay facing up and screw in the H hinges into the pre-drilled holes of the doors
10) hold door in place of the pre-drilled holes an then screw into the #7 and #8 side panels using F screws
11) There will now an “I” shaped beam #13. Take this I-beam and put it in the middle of the cabinet opening where the doors meet. Use the
provided screws and screw in the top 2 holes and the bottom 2 holes into the cabinet. This will give the cabinet extra support as well as
act as a door stop as well as filter out light that may be in the cabinet.
12) #14 are the 2 spring door openers. These 2 are installed on the top part of the I-Beam #14. Using the given screws in the packet, screw in
the 2 spring door openers on each side of the I-Beam (#14) on the upper flap.
Tips: H hinges are Euro hinges and there are 2 screws on each hinge. These 2 screws allow you to make adjustments of the doors. Giving you the
options of setting the doors closer or further apart from each other. Use a screw driver and adjust by hand so that you can be more exact
13) now that the cabinet is assembled, place the mat on top of the cabinet and place the tank on top of the mat. After the tank is sitting on
top of the mat, go to the underside of the cabinet and cut the mat to expose the drain and return hole.