P/N 9032069
Page 1 of 2
MMAC-PLUS 6 SECURITY BAR ADDENDUM
The MMAC-Plus 6 chassis is equipped with two security bars that prevent the unauthorized removal of the interface
modules. This addendum provides instructions to install the MMAC-Plus 6 security bars.
To install the MMAC-Plus 6 security bars, a flat blade screwdriver is needed.
INSTALLING THE SECURITY BARS
The two security bars supplied with the MMAC-Plus 6 chassis must be installed after all modules are in place. The two
security bars are identical. One security bar is installed across the top of the modules and the other is installed across
the bottom of the modules. The following steps should be performed to install the security bars.
1. To install the bottom security bar, orient the security bar with the securing tabs facing down and toward the chassis
as shown in Figure 1. Make sure that the heads of the screws are facing outward.
2. Lower the security bar behind the plastic tabs on the modules so that the holes in the securing tabs on the security
bar are aligned with the join in the beveled corners of the interface modules as shown in Figure 2.
3. Secure the bottom security bar to the chassis with the screws that are built into the security bar assembly.
4. To install the top security bar, orient the bar with the securing tabs facing up and toward the chassis.
5. Slide the security bar up, so that the holes of the securing tabs are aligned with the join in the beveled corners of the
interface modules.
6. Secure the top security bar to the chassis with the screws that are built into the security bar assembly.
Figure 1
Security Bar Orientation
Only qualified service personnel should perform the following procedures.
Securing Tabs
Security Bar Handles
Toward Chassis
Upper
Lower
Fastening Screws
