Cabletron Systems CyberSWITCH CSX150, Руководство пользователя

Страница: 355 / 620

Small Office Remote Access Switch 355
S
YSTEM
V
ERIFICATION
Verifying the AppleTalk Routing Feature
2. Look for the following message among the system messages:
AppleTalk routing initialized successfully
3. For the AppleTalk port that has been configured, the following port initialization message
should be displayed among the system messages:
AppleTalk successfully initialized on <port-type> with address
<net.node>
Note: <port-type> is either LAN port 1, LAN port 2 or WAN.
<net.node> is the AppleTalk address assigned to this port.
4. If you see these AppleTalk routing initialization messages, then the AppleTalk routing has
initialized properly.
If these messages are NOT displayed, refer to AppleTalk Routing Initialization in the Problem
Diagnosis chapter.
V
ERIFYING
A
PPLE
T
ALK
R
OUTING IS
O
PERATIONAL
To verify that AppleTalk routing is properly operational, a remote Macintosh must be operational
and available to initiate WAN connections via a remote AppleTalk router device. Also, a local
Macintosh device must be connected to the local LAN port on the CyberSWITCH.
Below is an example of a configuration used to verify AppleTalk Routing operation. It uses
AppleTalk addresses, zones and resource names specific to the example. Substitute those of your
network when you perform the AppleTalk Routing feature verification steps.
ISDN
CSX150
"Site1"
CSX1200
"Site2"
Net Range: 10-11
Zone: Left Zone
Net Range: 20-21
Zone: Right Zone
Local Mac Remote Mac
WORKGROUP REMOTE ACCESS SWITCH
LAN
10BASE-T RX TX SERVICE
CH-2
D-CH
CH-1
SYNC
POWER
LINE
1
CH-2
D-CH
CH-1
SYNC
LINE
2
CH-2
D-CH
CH-1
SYNC
LINE
3
CH-2
D-CH
AGI
CH-1
SYNC
LINE
4